Trailer!

Bought a brand new trailer yesterday. Was not really in the budget, but I think that it's a necessity. 

Rudder temporarily mounted

Drilled the transom and temporarily mounted the rudderbox/tiller. Also marked for the front and back seat top supports. 

Mast support

Started by trying to route out the hole in the center. Did not turned out well so I used the jigsaw instead. 

Centreboard still fits

Of cause it would have been a bit easier to open out the centreboard slot later with the boat upside down. Was much too curious to see if the board still fits the box. It did with enough space to account for the glass and paint still to be applied. Routing upside down was a messy affair though. I don't think I'll learn to like to work with electric routers, but it got the work done.

Centre board case in

It's a mm or two offset, but I think I got it straight and square. 

Bottom is on!

Now it's boat. If I were to put her in water  she would float. Lots of work left though until she's ready for real, but it's getting there